48V Gigabit POE Injector with 48V 0.5A Output and Surge Protection, (4/5+,7/8-), MIT-07G-48BNNN

Function :
- Transforms AC power to 24V DC power
- Injects 48V DC through a CAT-5 cable 4,5,7,8-pin, into remote devices such as wireless AP, IP phone and web camera
INPUT :
- Input voltage: AC 100V ~ 240V
- Input current: 0.49A at 100Vac；0.27A at 240Vac
- Input Frequency: 50-60 hz
OUTPUT :
- Output voltage and current: 48V
- Max load: 0.5A
- Power: 24W maximum
- Minimum load: 0A
- Load regular percentage: 5%
- Line regular percentage: 1%
- Ripple percentage: 1%
- Noise percentage: 1%
- Total power: 24W
- Noise bandwidth is from DC to 20Mhz.
- Ripple & Noise is measured by Paralleling a 0.1Uf metalized capacitor on the test point.
Efficiency : 87% min at Full Load , 100Vac & 240Vac Input Voltage
Protection :
- Short-circuit protected
- Output Short GND Terminal will not damage the Power Supply and will Auto-Reset.
- Input with Fuse Protection.
- High Pot: 4242Vdc, 60Sec, Input Terminal to output Terminal.
- Meet Level 6 (USA-VI )
General description :
- Operating temperature: -40 to 40 degree Celsius
- Storage temperature: -40 to 85 degree Celsius
- Operating humidity: 5 to 90%
- Free air cooling
- Size: 86*78*36 mm (L)*(W)*(H)
- DIN rail mountable by clip kit (option)
RJ-45 input (data only) and RJ-45 output (data & power)
Indicator :
- LED (GREEN) indicates PWR – OK

Installation
To install the Gigabit PoE Injector, please follow the steps below.

Connect the DATA IN port on the Gigabit PoE Injector to a switch or HUB with an RJ-45 cable.
Using an RJ-45 cable, connect the DATA OUT port on the Gigabit PoE Injector to a PoE splitter, PoE device (such as a router, access Point, etc.) or a PoE Hub.
Plug in the power connector of the Injector to a connect dc power outlet.
The product fixed installation, please refer to the figure 1.
Before starting, ensure all connections are correct.

The Gigabit PoE Injector connects to the Splitter, PoE Hub or POE device through the DATA OUT port.
The Gigabit PoE Injector connects to the switch through the DATA IN port.
The POWER IN port is receiving power from the dc power outlet.

Start connecting the operating voltage solely if all the above requirements are fulfilled.

Our Products

MIT-07G-48BNNN