Product

24VAC PoE
24VAC Input 70W Output High-power PoE Injector with Overload Protection
Key Specifications/Special Features
  • INPUT :
    • Input voltage: 22Vac to 35Vac Normal = 24Vac
    • Input current: 5.720A at 24Vac/50hz F.L; 6.47A at 22Vac/50hz F.L; 3.95A at 35Vac/50hz F.L
    • Input Frequency: 50/60hz 
    • Power Factor: >0.53(at F.L) suggest : initial add Inductor
  • OUTPUT : 
    • Output voltage and current: +56V2
    • Max load: 1.25A
    • Power: 70W maximum
    • Minimum load: 0A
    • Load regular percentage: 5%
    • Line regular percentage: 1%
    • Ripple percentage: 1%
    • Noise percentage: 1%
    • Total power: 70W
    • Noise bandwidth is from DC to 20Mhz.
    • Ripple & Noise is measured by Paralleling a 0.1uF metalize capacitor on the test point. 
  • Efficiency: 80% min at Full Load , 22Vac ~ 35Vac Input Voltage 
  • Protection:
    • Short-circuit protected
    • Output Short GND Terminal will not damage the Power Supply and will Auto-Reset. 
    • Input with Fuse Protection. 
    • Over Current:  802.3bt Limits @All AC Input F.L 
  • Safety Standard : meet UL1950, CSA 22.2 & TUV EN60950-1
  • EMC : meet FCC Class B , EN55032 Class B 
  • Warning : Input Fuse(T5A-125V) Must be installed at Line and Line. (The fuse must be installed on one of the wires.) It is strongly recommended to install an inductor at the input (minimum 1mH) The ground of the power supply must be connected to the ground of the load, and also to the ground of the machine.
  • General description:
    • Operating temperature: -40 to 70 degree Celsius
    • Storage temperature: -40 to 85 degree Celsius
    • Operating humidity: 5 to 90%
    • Free air cooling
    • Size: 125*72*38 mm (L)*(W)*(H)
    • DIN rail mountable : DIN rail clip kit optioned
  • RJ45 Pin Assignment: @1000M
  • RJ-45 input (data only) and RJ-45 output (data & power)
  • Indicators
    • the LED on top cover light GREEN when Power Ready
    • the LEDs on right RJ45 light GREEN when powering to 802.3BT PD, the left LED ON means the data pairs powering, the right LED ON means the spare pairs powering. If no valid PD be connected, the two LEDs light off. 
History
    3Inquiry